Milescraft 1324 Pocket Jig 100
PocketJig100 pocket hole jig allows you to connect your workpieces in a quick and timely manner or do repairs around your house. Small, compact design allows you to do applications where a small jig is required. Built-in board thickness locations for easy measurement and set-up of your workpieces, virtually eliminating the need for manual measurements. Everything you need to get started with your first pocket holes!
- PocketJig100 – Designed To Make Repairs Simple
- No fence and the small design allows you to get into some of the smallest places to make repairs to many joints
- Hardened Steel 3/8” Drill Bushing
- For precise and accurate pocket holes every time using the Milescraft PocketBit
- Tight tolerances between the bushing and the drill bit, reduce tear-out and create a clean pocket hole on the first try
- Recessed Clamp Pocket with Magnet
- Helps to keep the clamp in the same position as you move to different locations
- With the stronger rare earth magnet, you can easily clamp the jig from one location to another
- For speed and accuracy, use the Milescraft 3” Face Clamp
- Board Thickness Settings
- Four common board thickness settings built into the jig: 1/2”, 3/4” 1” and 1-1/2” (12, 19, 27, 38mm)
- Convenient Built-in Depth Setting
- Easily set your bit for the correct drilling depth
- 3/8″ Split Design Stop Collar with Flat
- The split design prevents slipping of the set screw when tightened and the flat prevents the bit from rolling
- Includes hex key for tightening
- 3/8″ HSS Step Drill Bit
- Made from high-speed steel the PocketBit with 1/4″ hex shaft is designed to reduce clogging and provide smooth and precise holes
- 6” Magnetic T20 Star Driver
- For maximum torque settings without stripping
- Allows pocket screws to align with maximum precision
Includes:
- Single Barrel Pocket Hole Jig
- 3/8" (9.5mm) PocketBit
- 3/8" Stop Collar
- 6" Magnetic T20 Star Driver
- Hex Key
- Instruction Manual
Specs:
- Jig Body Material: Reinforced Nylon
- Clamping Method: Works with any clamp
- For use with: Wood Materials from 1/2" t0 1.5" thick (12 - 38mm)
- Drilling Angle: 15°
- Driver: Magnet 6" T20 Torx Driver
- Drill Bit: 3/8" (9.5mm) HSS Pocket Bit with 1/4" shank